![]() wpa_supplicant -B -i interface -c /etc/wpa_supplicant/nf ![]() Then using wpa_supplicant itself supply -B for background mode, -i for the target interface and -c for the config file. wpa_passphrase SSID passphrase > /etc/wpa_supplicant/nf Connect Using wpa_passphrase we can generate the required config. I know the SSID and passphrase of the wifi in question. I can find this with ip link and looking at the available devices. On my Thinkpad the wifi interface is named wlp58s0. Common things are: killall dhcpcd wpa_supplicant Generate a configuration Wpa_supplicant -B -i interface -c /etc/wpa_supplicant/nfĮither reboot or killall any leftovers from your previous hacking to ensure you begin with a clean slate. Wpa_passphrase SSID passphrase > /etc/wpa_supplicant/nf This guide was written with Arch in mind but will just as well work with any modern Linux distro. Here's a quick set of instructions including a couple of gotchas that might help you. Sometimes via ethernet, sometimes WiFi is the only option. So what do you do about this? Get online ASAP. You can further verify everything is still working after reboot by systemctl reboot then ping something.It's quite easy to get tied in knots when dealing with the early stages of an Arch install because you're offline. Use systemctl -type=service to ensure that no other network service is running before enabling a netctlprofile/service.Īfter you double check that there’s no other network services running, nor will be loaded on boot, start this service: # systemctl enable wlan0 with your own wifi interface name. Warning: Do not enable concurrent, conflicting network services.If you have previously enabled a profile through netctl, run netctl disable profile to prevent the profile from starting twice at boot.Then run pacman -S wpa_actiond, otherwise it might will throw 404 error. Noted that you might need to update the system first pacman -Syu. Then follow the GUI screen guide to finish the wifi setup, and verify that the connection is good: # ping Then install the wpa_actiond package. ![]() I choose to use netctl because it is part of the base group, i.e., it should be already part of the system. I want to auto connect to network on boot, and switching between profiles automatically (home/office/other environment). Now we verified that everything works on a low level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |